China Supplier Manual Icu Bed - One function hospital bed – Webian

Instruction Manual of hospital bed

Manual one function hospital bed

as the label

1. Bed Headboard
2. Bed Footboard
3. Bed-frame
4. Back panel
5. Welded bed panel
6. Crank for back lifting
7. Cranking mechanism
8. Casters
9. Guardrails
10. Toilet hole device
11. Crank for toilet hole
12. Toilet hole

It is suitable for patient nursing and recuperation.

1. ABS Bed headboard and footboard as Figure 1
Install the groove of headboard and footboard with the bed frame, and locked with the hook of headboard and footboard
2. IV stand: insert the IV stand in the reserved hole.
3. ABS dinning table: Put the table on the guardrails and clamp it tightly.
4. Aluminum or stainless steel guardrails: Fixed the guardrail with screws through the holes of guardrail and bed frame.

1. Back rest lifting: Turn the crank clockwise, the back panel lift
Turn the crank counterclockwise, the back panel down.
2. Toilet hole: Pull out the plug, the toilet hole is opened; push the toilet door, then insert the plug, the toilet hole is closed.
Toilet hole with crank device, turn the crank clockwise to open the toilet hole, turn the crank counterclockwise to close the toilet hole

1. Check that the headboard and footboard were fasten tightly with bed frame.
2. The safe working load is 120kg, the max load weight is 250kgs.
3. After installing the hospital bed, place it on the ground and check whether the bed body shakes.
4. The drive link should be lubricated regularly.
5. Check the casters regularly. If they are not tight, please fasten them again.

The packaged products can be transported by general ways of transport. During the transportation, please pay attention to preventing sunshine, rain and snow. Avoid transportation with toxic, harmful or corrosive substances.

Packaged products should be placed in a dry, well-ventilated room without corrosive materials or heat source.